CL10 is constant AE event rate loading

------------------------------------------
Active seismic recordings:

/CL10_ACTIVE_SEISMIC/
bottom_sensor_active_CL10.ascii  % recordings from receiver at the bottom and source at the top / 16384 rows (individual waveform time-series with dt=2e-8s) vs. 23 columns (individual shots)
top_sensor_active_CL10.ascii     % recordings from receiver at the top and source at the bottom / 16384 rows (individual waveform time-series with dt=2e-8s) vs. 23 columns (individual shots)
times_sec_from_loading_active_CL10.ascii  % timing of individual shots as seconds from loading time (23 entries)
Note: This is raw data, recorded at 70db pre-amp gain

------------------------------------------
Acoustic emission recordings:

/CL10_AE/
bottom_sensor_AE_CL10.ascii % recordings from bottom receiver / 16384 rows (individual waveform time-series with dt=2e-8s) vs. 3601 columns (individual AE)
top_sensor_AE_CL10.ascii % recordings from top receiver / 16384 rows (individual waveform time-series with dt=2e-8s) vs. 3601 columns (individual AE)
times_sec_from_loading_AE_CL10.ascii % timing of individual AE as seconds from loading time (3601 entries)
Note: This is raw data, recorded at 70db pre-amp gain

------------------------------------------
Estimated system delay through sample:
This estimate was based on an experiment whereby the pistons touched together (sample-less experiment)
2.6493e-05s to correct for pistons and for any external factor delay (recording system etc)